11
Surround Assembly
1) Lay Parts A, B, and C face down on a flat, non-marking
surface (Fig. #19). Fasten together with spring clips or
1/4" x 1/2" bolts through holes at points "D" (Fig. #22).
2) Lift the surround assembly to the upright position and
make sure the front face is even at the joint.
3) Assemble the three brass trim pieces using the enclosed
hardware. Slide Part F into the back corners of the brass
trim and tighten screws. Ensure the mitred corners fit
tightly and evenly (Fig. # 20).
4) Slide the assembled brass trim over the surround from the
top (Fig. # 19).
5) Tighten the retaining screws at the bottom of each brass
trim side (Fig. # 23).
Fig. # 23
Fig. # 21
Fig. # 20
Fig. # 22
Fig. # 19
Brass Trim
Retaining Screw
8) Push the entire appliance back until the surround is in
contact with the fireplace.
Part F
Brass Trim
D
Part A
D
Part C
Part B
Brass Trim
6) Connect the wire from the spill switch to the on/off rocker
switch in the brass trim (Fig.# 21).
7) Slide pre-assembled surround on to insert.
Do not lift the
assembly by grasping the brass trim.
The surround is
held in place by 2 screws just inside the casing near the top
and bottom. Push surround back until snug and even with
front face of insert. Fasten in place.
Part C
D
Part A
f i r e - p a r t s . c o m
Summary of Contents for E Series
Page 18: ...18 Fig 36 fire parts com...
