4
Safety
• Due to high temperatures, this gas appliance should be
located out of traffic and away from furniture and dra-
peries.
• Children and adults should be alerted to the hazards of
high surface temperature and should stay away to avoid
burns or clothing ignition.
• Young children should be carefully supervised when
they are in the same room as the appliance.
• Clothing or other flammable material should not be
placed on or near the appliance.
• Any grill, panel or door removed for servicing the unit
must be replaced prior to operating. Failure to do so may
create a hazardous condition.
• Installation and repair should be done by a qualified
service person. The appliance should be inspected before
use and at least annually by a professional service person.
• More frequent cleaning may be required due to exces-
sive lint from carpeting, bedding material, etc. It is im-
perative that control compartments, burners and circu-
lating air passageways of the appliance be kept clean.
It is Pacific Energy’s policy that no responsibility is assumed
by the Company or by any of its employees or representatives
for any damages caused by an inoperable, inadequate, or
unsafe condition which is the result, either directly or indi-
rectly, of any improper operation or installation procedures.
Fig. # 2
THERMOCOUPLE
THERMOPILE
PILOT
FLAME
ELECTRODE
Maintenance
Caution:
Turn off gas and electrical power supply and allow
ample time for unit to cool before servicing appliance. It is
recommended that this appliance and venting should be
inspected at least once a year by a qualified service person.
Do not use this heater if any part has been under water.
Immediately call a qualified service technician to inspect the
heater and to replace any part of the control system and any
gas control which has been under water.
Glass Panel:
Warning:
Do not operate appliance with glass panel re-
moved, cracked or broken. Replacement of the glass panel
should be done by a licensed or qualified service person.
Do not strike or otherwise impact the glass in anyway that
may cause it to break. If the glass becomes cracked or broken,
it must be replaced before using the fireplace. Replacement
glass can be obtained from your nearest Pacific Energy
dealer. The size required is 13 3/4" x 27 3/8" x 5mm. Use
ceramic glass only.
Do not substitute with any other type.
To remove broken glass, fold down the front bottom louver
to access the window latches.
Disengage the over-center latches by pulling each lever down
and forward. Grasp the sides of the frame and swing the
bottom out to clear. Lift up and forward to disengage from the
top.
Remove all particles of glass. Be careful as they are very
sharp. Install new glass complete with gasket. Replace frame.
Annual Inspection:
1) Clean louvers and air passage ways of excessive lint
buildup from carpeting, bedding material, etc. The flow of
combustion and ventilation air must not be obstructed.
2) Remove glass frame assembly and log set. Inspect logs
and burner assembly for lint and soot buildup. If excessive
buildup of soot is present, have a qualified service person
inspect and adjust unit for proper combustion. Clean logs and
burner with a vacuum cleaner, paying close attention to
burner ports.
3) Check the pilot system for proper operation (See Fig. #2).
4) Check that the chimney flue and its outlet are open and
free from blockage or debris.
5) Check glass panel gasket, replace if necessary.
Note:
The appliance area must be kept clear and free from
combustible materials, gasoline and other flammable vapors
and liquids.
Periodically:
a) Viewing glass may be cleaned with glass cleaner.
b) Exterior porcelain enamel finish may be cleaned with soap
and water.
Note:
Never use abrasives to clean this appliance.
