Assembly
12
/
11
Attaching the canopy fabric
8
L
M
Secure the assembled poles (L) and (M) onto the long beams without the pole receivers (Q) with bolts (BB) using hex wrench (FF). (Fig.8.1)
On both short sides of the pergola, tie the canopy to the rings inside the rails of the side cross beams (J) with the elastic band (2). (Fig.8.2)
Secure poles (N) and (O) onto the rings inside the rails of the side cross beams (J) with bolts (AA) using hex wrench (FF). (Fig.8.2)
Allow the poles (N) go through the rings inside the rails of the central beams (K) and insert into the poles (O). (Fig.8.3)
Hook the canopy pull (R) in the small hole of the ring (1) which is nearest to the pole receivers (Q).(Fig.8.4)
Hammer ground stakes (HH) into the post bases to stabilize the pergola. (Fig.8.5)
You can adjust the canopy coverage by pulling the canopy pull (R) forward or backward.
When the first pole (which goes through ring (1) ) clicks into the pole receivers (Q), the canopy is fully extended.
N
HH
(Fig. 8.2)
(Fig. 8.5)
R
BB L,M
F,G
O
2
1
(Fig. 8.3)
(Fig. 8.1)
AA (10)
BB (3)
Bolt (M6x16)
Bolt (M6x30)
Fig. 8.4
□
□
□
□
□
□
□
□
AA
Cover all the bolts with bolt caps (GG).
GG
GG (65)
Bolt caps
