First, separate the 16-conductor ribbon cable into 4-conductor
sections giving a total of 4 sections of 4 wires each.
Strip the ends of the wires back a half-inch or so,
and twist them together.
Crimp the terminal and use electrical tape or
heat shrink tubing to strain relief the connection.
Separate the sets of 4 wires into two wire sets
from the end up to the strain relief on the ring
terminal.
This will form 2 radial wires connected to each
ring terminal. Each radial will have 2 parallel conductors.
PAC12_Manual
V3.0_20160712
