©2012 PACE Inc., Southern Pines North Carolina
Page 6 of 9
All Rights Reserved
www.paceworldwide.com
PS-90 Tip Installation
For maximum productivity and proper fit, install tips into your soldering iron when the heater is hot
CAUTION:
To avoid burns or potential injury, always hold the handpiece with the heater pointed at an angle
up to prevent injury.
1. Insert the Tip fully into heater bore using the supplied Tip Tool.
2. Gently tighten the heater Set Screw.
3. Recheck the tip Set Screw periodically to insure that it remains
snug.
PS-90 Heater Replacement
If replacement becomes necessary, perform the following procedure to ensure optimum performance and
maximize the life expectancy of the heater.
1. Allow the heater to cool.
2. Remove the Heater Retaining Nut.
3. Pull the Heater Assembly from the Handle. Discard defective Heater Assembly.
4. Align the connector key on the handle end of the replacement Heater Assembly with the keyway slot
on the handle.
5. Push the Heater Assembly fully into the handle.
6. Replace the Heater Retaining Nut and tighten by hand.
Spare Parts
Item #
Description
PACE Part Number
1
PS-90 Flat Ring
1500-0076-P5
2
PS-90 Heater Assembly (also fits PS-80)
6010-0095-P1
3
PS-90 Flared Ring
1500-0074-P5
4
Retaining Nut for PS-70/PS-90
1410-0122-P5
5
Heater Set Screws
1348-0547-P10
Service
Please contact PACE or your local distributor for service and repair.
PACE WORLDWIDE LIMITED WARRANTY STATEMENT
Limited Warranty
Seller warrants to the first user that products manufactured by it and supplied hereunder are free
of defects in materials and workmanship for a period of one (1) year.
from the date of receipt by
such user. This Warranty as applied to blowers, motor pumps, x-ray tubes, lenses,
optical/lighting probes and cameras is limited to a period of one (1) year. Monitors, computers
and other brand equipment supplied but not manufactured by PACE are covered under their
respective manufacturer’s warranty in lieu of this Warranty. This warranty does not cover wear
and tear under normal use, repair or replacement required as a result of misuse, improper
application, mishandling or improper storage. Consumable items such as tips, heaters, filters,
etc. which wear out under normal use are excluded. Failure to perform recommended routine
NOTE
Periodically, clean the heater bore with a properly sized
wire brush (3/16" O.D. to insure optimum heat transfer
and proper tip grounding when.