5
Xi3 (PX032ANI) USER GUIDE (501-3410500)
Serial No: PADA00000001
CCS1234N12345678
CCS1234N12345678
DM MAC: 11:22:33:44:55:1ASerial No: PADA00000001
CCS1234N12345678
CCS1234N12345678
DM MAC: 11:22:33:44:55:1A
Safety aspects of connections
Full details of the rear panel are on page 6.
Connecting
Do not connect your set-top box (or any other equipment such as a TV or
VCR) to the power supply until you have properly connected all the other
cables.
Your set-top box operates with an AC power supply voltage, as shown on
a label on the base of your set-top box. Do not connect your set-top box to
a DC supply or to any other power supply.
This set-top box is equipped with a two-wire power cord, with a polarized
plug at one end. The other end of the cord is fitted with a polarized
connector, which is shaped such that it can be fitted only one way into the
power input connector of your set-top box. Connect this end first, before
inserting the polarized plug into the wall AC outlet.
Disconnecting
Disconnect your set-top box from the AC power supply before you
disconnect any other equipment from its rear panel.
The only way to disconnect your set-top box from the AC power supply
is to remove the power cord from the wall AC outlet. Therefore, you must
install your set-top box near to the wall AC outlet, which should be easily
accessible.
If you are in any doubt about the power supply cord, its plug or its
connection, or are not certain that the electrical outlets you are using
are properly wired and grounded, consult a qualified electrician before
proceeding any further.
SAFETY INFORMATION (cont.)
The
CABLE IN
connector is designed
for connection to a cable network only.
You must not connect any other
equipment, such as a VCR, to this
input.
POWER INPUT
Regulatory information
NOTE
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. End users must follow the specific
operating instructions for satisfying RF exposure compliance. This
transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.
FCC RF Radiation Exposure Statement
MPE/SAR/RF Exposure Information.
This equipment complies with FCC RF radiation exposure limits set
forth for an uncontrolled environment.
This equipment was verified for RF exposure and found to comply with
Council Recommendation 1999/519/EC and FCC OET-65 RF exposure
requirements.
WARNING:
While this equipment is in operation, a separation distance
of at least 20 centimeters (equal to 8 inches) must be maintained
between the antenna inside the equipment and the bodies of all
persons exposed to the antenna in order to meet the FCC RF exposure
guidelines. Making changes to the antenna or the equipment is not
permitted. Doing so may result in the equipment exceeding the FCC
RF exposure guidelines. This equipment must not be co-located or
operated in conjunction with any other antenna or radio transmitter.
FIRST
DRAFT
