Pace Technologies TERAPRESS TP 7500S, Instruction Manual, Page: 12 / 59

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
TERAPRESS TP 7500S
Mounting Press
Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 - 520 - 882 - 6598 Fax +1 - 520 - 882 - 6599 email: pace@metallographic.com Web: https://www.metallographic.com
Serial name
plate
Backside connections
Electrical connection: Verify the operating voltage which is printed on the name plate. The
standard voltage is 110V. However, the system is also available in
220V. IT IS ALSO RECOMMENDED THAT NO EXTENSION
CORDS OR MULTIPLE OUTLET CONNECTORS BE USED AS THIS
MAY CAUSE THE FUSE TO OVERHEAT BUT NOT BLOW DURING
OPERATION!
Coolant drain: The coolant drain line requires a 1/4 - inch hose. CAUTION: The mold
temperature is very hot and the initial contact of the cooling water
turns to steam, which exits the drain hose at a very high temperature.
Coolant supply: The coolant supply line requires an 8 mm hose. It is recommended
that the water supply be turned off when the unit is not in use. Inlet
water should be clean and contamination - free to extend the life and
cooling performance of the system.
Main power switch
Electrical connection
Drain
8
Water