SWITCHBLADE SERIES® 6
First, ensure that the Foam Washer is in place on the Drain Fitting as this washer will
help prevent water leakage. Next, test fit the drain tube to determine the length you
want to trim it. Always caution on the long side. Trim the end that will be inserted
through the truck bed using the wire cutters or a utility knife.
With the cover opened, insert the drain tube fittings into the pre-drilled holes on the
underside of the canister by pushing them in place from under the canister. Drain
Fitting should click into place.
Place the other end of the drain tube through the plastic/rubber access port or
through the pre-drilled holes in the floor or the front wall of the truck bed. If routing
through the front wall, ensure that the drain tubes are inserted and directed down so
the water flows out of the truck bed.
To remove the drain tubes reach under the canister, grab the drain tube fitting and
turn it while applying light downward pressure. When the retaining tabs align with
the notches in the bottom of the canister the Drain Tube and Fitting will drop out.
STEP 8: INSTALLING THE DRAIN TUBES
STEP 9: ATTACHING TOP COVER & VELCRO TO PULL-STRAP
4” Velcro Strip
Place the Top Cover on the canister and install
with the four Black Top Cover Screws through
the top cover endcaps and into the panel nuts
on the canister flanges.
Retract the cover to the fully open position.
Attach the 4” Velcro Strip onto the Velcro al-
ready attached to the pull-strap.
Pull the pull-strap over to the driver or passen-
ger side rail and remove the tape from the 4”
Velcro Strip.
Then apply the Velcro Strip onto the underside
of the rail at your desired position.
This will hold the pull-strap off of the floor and
out of the way when cargo is being stored in the
truck bed.
HARDWARE USED:
Black Top Cover
Screw x4
You have now completed the installation of your JackRabbit Series tonneau cover!
If you have any questions, please do not hesitate to call us at (800) 338-3697 Ext 1
to speak with our Technical Service Department.
FIG. 8A
