Paccar Peterbilt 320, Operator'S Manual

Page: 25 / 212

PART 4: CONTROLS AND DISPLAYS High Beam Headlights
NOTE: The ignition key must be turned to ON for
the signal/switch to operate.
To operate either signal, move the lever in the direction of
the turn.
Hazard Flasher
The four-way Hazard Flasher switch is on the turn signal
body, just below the turn signal lever.
• At a right-hand drive station, the switch is above the
lever.
The fl asher will operate with the key switch in the on or off
position. Pull it out to activate the system. All turn signals
will
fl ash at once. To turn it off, move the turn signal lever
up or down.
Use your hazard fl asher whenever you are off the road or
on the side of the road, or in a potentially hazardous situa-
tion.
WARNING! Use your Hazard Flasher Warning
System any time you have to stop off the road or
on the side of the road, day or night. A hard to
see vehicle can result in an injury accident. An-
other vehicle could run into you if you do not set
your
fl ashers. Always move the vehicle a safe
distance off the road when stalled or stopped
for repairs
Of course, in normal stopping in traf fi c, such as at a stop
light, you do not use your fl ashers.
WARNING! Your disabled vehicle can be dan-
gerous for you and others. The hot exhaust sys-
tem could ignite dry grass, spilled fuel, or other
substances. Do not park or operate your vehi-
cle where the exhaust system could contact dry
grass, brush, spilled fuel, or any other material
that could cause a
fi re.
High Beam Headlights
All Model 320 vehicles come equipped with a combina-
tion turn signal and high beam / low beam switch that is
mounted to the steering column. To switch your headlights,
push and release the button on the end of the turn sig-
nal lever. The high beam indicator light is displayed in the
tachometer face
R(08/07) Y53-6015 – 21 –