6. Install the output planet carrier into the drum while
meshing the planet gears with the ring gear and the
planet housing with the bearing support.
7. Install the primary sun gear and thrust washer into the
primary planet carrier.
8. Install the primary planet carrier, meshing the planet
gears with the ring gear and the planet housing with
the output sun gear.
9. Install a new bearing in the drum closure as required.
Use sealant on the outside surface of the oil seal.
Install with spring side of the seal toward bearing,
using a flat plate to avoid distortion.
Install a new O-ring in the groove on the O.D. of the
drum closure.
10. Lubricate the O-ring and drum opening with petrole-
um jelly or gear oil and install the drum closure into
the drum.
11. Lubricate the pilot, oil seal and bearing surfaces of the
brake cylinder and carefully install brake cylinder into
base and drum. Locate the brake release port toward
the lower rear corner of the base. Tighten brake cylin-
der capscrews to recommended torque.
27
O-RING GROOVE
Summary of Contents for BRADEN Gearmatic BG6A
Page 2: ......
