6
SWI-RC
Step F.
Repeat Steps D and E, using the TEMP DOWN Button.
Step G.
If the vehicle is equipped with FAN UP and FAN DOWN buttons:
Repeat Steps D and E for these buttons as well.
Step H.
If the vehicle is NOT equipped with FAN UP and FAN DOWN buttons:
Press and release the programming/
mode button on the SWI-RC.
SWI-RC
In either case, the
LED will flash once
and stay on.
Appendix A. (Continued)
SWI-RC
Step J.
Release the button.
The LED will turn on
back on.
Step I.
Within 7 seconds
, press and
hold for 5 seconds
the button that
is to be learned on the steering
wheel.
The LED will turn off
during this process.
SWI-RC
VOL
VOL
Step K.
If you need to program more buttons,
repeat steps I & J for each additional
audio function on the steering wheel.
Program
remaining buttons
SWI-RC
Once programming is
completed,
wait 7 seconds
.
The LED will flash three times
indicating end of programming.
The Interface will then flash
the version number it was
programmed for.
Step L.
After all buttons are
programmed
Testing the SWI-RC
A.
When testing the audio controls, the left LED on the
SWI-RC will flash indicating it is sending a command.
If any function does not work, repeat the programming
instructions (starting from Step 11) or refer to
Troubleshooting Guide.
B.
(For Version #4 only) Test each Heater function of the
steering wheel controls. The TEMP and FAN should work
properly.
VOL
TEMP