Stinger HEIGH10
Radio Replacement Kit
for 2014-2021 Toyota Tundra
SR-TUN14H
© 2022 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global. PAC-audio.com
Pacific Accessory Corporation
Page 7
Rev: V2
Date:032222
®
®
Step 6
Step 5
Step 4
Align the right side bracket holes to
the main frame mounting holes and
secure using two #10x3/8” screws
from the SR-TUN14H hardware.
Align the left side bracket holes to
the main frame mounting holes and
secure using two #10x3/8” screws
from the SR-TUN14H hardware.
Plug the display cables into the back
of the HEIGH10 display.
Place the complete radio and side
bracket assembly face down on the
main frame.
Section 5:
Main Frame Assembly
Step 2
With the display face down on a
soft surface, attach the display
to the panel using four M4 x
12 screws from the HEIGH10
hardware pack.
Step 1
Place the HEIGH10 display into
the main frame panel. Carefully
turn the panel over while holding
the display in place.
Step 3
Step 7
Route the LVDS (USB) and 8-pin
display cables to the front of the
assembly, passing between the
radio module and the interface
bracket.
Remove the two retaining clips from
the factory radio and install them
in the same location on the
SR-TUH14H main frame.
