RP4-FD11
Radio Replacement & Steering Wheel Control Interface
for Ford/Lincoln/Mercury Vehicles
Rear Seat Entertainment (RSE); If equipped
If you would like the RSE system’s audio to play
through the aftermarket radio:
First set the aftermarket radio to Aux input.
Press
the Power button on the RSE & insert a DVD. You
should now hear the RSE audio on the aftermarket
radio. If the RSE audio is only playing on the front
speakers the RSE is set to dual play mode. Press
the Dual Play button on the RSE controls until
“Single Play” is displayed across the top of the RSE
screen.
RSE Audio Modes -
There are 2 different modes for
the RSE audio, they are Single Play & Dual Play.
1. Single Play -
Press the Dual Play button on
the RSE controls until “Single Play” is displayed
across the top of the RSE screen. In this mode the
RSE audio is played throughout all speakers in the
cabin.
2. Dual Play -
Press the Dual Play button on the
RSE controls until “Dual Play” is displayed across
the top of the RSE screen. In this mode the
rear speakers will be muted & the RSE audio is
transmitted through the factory IR headphones
while the front passengers can now listen to
whatever source they like.
RSE Operation Notes:
1. If the vehicle is equipped with RSE with single
play/dual play button on the monitor in the
headrests, the driver side monitor is the master
source unit. The source on the passenger
headrest cannot be viewed on the driver side.
2.
Both monitors must turn headphones off in order
to hear RSE audio through radio.
3. Monitors without single play/dual play button
on monitor operate independently and audio
can never be passed to the new radio. In these
vehicles RSE audio comes from aux in on back of
center console.
4. In 2011+ vehicles the car must be in ignition mode
for the RSE to operate properly. Being in accessory
mode will cause erratic behavior.
ENTER
MENU
RETURN
VOLUME
MEDIA
Vehicles With Overhead Monitor
Dual Play
Button
MEDIA
MENU
SEL
Vehicles With Headrest Monitor
Dual Play
Button
Product Updates (Firmware)
The RP4-FD11 can be updated with new firmware as it becomes available using the PAC-UP interface updater (sold separately).
Page 4
