Stinger HEIGH10
Radio Replacement Kit
for select 2014-2019 Silverado/Sierra Truck
RB10
GM14
B
© 2020 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
Pacific Accessory Corporation
Page 15
Rev: V1
Date: 030121
®
®
Step 7
Connect the radio side of BAA22
Antenna Adapter (1) to the
HEIGH10’s AM/FM antenna input.
Plug in the 6 pin SWC / EXT IR
harness (2).
2018-19 IOB Only:
Plug the 20
pin harness that was removed
from the factory display into the
GM5CAM-DIS-HAR.
Step 6
1
2
Section 5: Radio Unit Installation (cont.)
Part One: In-Vehicle Harness and Cabling Connections (cont.)
These are the connections for a typical installation. If adding additional cameras,
amplifiers or satellite radio, those connections should be made at this point, before
mounting the radio module.
Part Two: Radio Unit Mounting
Step 2
Step 1
Step 3
The plastic panel in front of the
CD/DVD cavity is narrower than
the cavity itself and will prevent
the side bracket screws from
passing. The side bracket screws
will need be angled up and over
this panel as it is put in place.
With the Chime Module and both
display cables routed over the top,
place the RP5 interface on top of
the radio module and slide it into
CD/DVD cavity as noted in Step 2.
Once in place, secure the radio
assembly with two 7mm screws.
Zip tie the Chime Module in
a suitable location. Use the
supplied two-sided tape to secure
the RP5 interface to the top of the
radio module.
