GM1A-RS
Radio Replacement Interface with
Steering Wheel Control Retention
for select General Motors Vehicles
with Class II Data-Bus
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Rev: V8
Date: 080118
Page 3
Alpine
JVC
Kenwood
Clarion
Pioneer
Sony
Fusion
Volume -
Volume -
Volume -
Volume -
Volume -
Volume -
Volume -
Volume -
Seek Up
Track +
Track +
Track +
Track +
Track +
Track +
Seek Down
Track -
Track -
Track -
Search -
Track -
Track -
Track -
Preset
Preset Up
Preset/Disk
Down
Preset
Mute
Preset Up
Preset Up
Audio
Voice
VR
VR
VR
VR
VR
VR
Mute
End
End
Reject
On Hook
End
End
Answer / End
Source
Default SWC Button Assignments (Corvette)
Default Steering Wheel Control Programming
Default SWC Button Assignments
Programming Button and Adjustment Dial Functions
You can press and hold the programming button on the side of the interface to access different programming modes. Once the
LED is lit to the mode you desire (see below for modes), immediately release the programming button to access that mode.
PLEASE NOTE:
• This process must be done with the interface in the vehicle and the key in the ignition position.
•
If there is a Premium Bose system (Y91 / UQA), and you are also installing an amplifier on the cabin speakers,
make sure that the chime speaker is connected before proceeding. See the RadioPRO app section on Page 5 for
more details.
A.
1 Chime and LED 1 flash green:
SWC re-assignment
. This allows you to re-assign the SWC functions to the buttons
of your choice. Please see the Optional Steering Wheel Control Programming instructions on Page 4 for more details.
B.
2 Chimes and LED1 flash amber:
SWC re-calibration
(this mode is available in the
Corvette only
).This allows you
to re-calibrate the analog SWC in the event they fall out of the expected range and do not function properly. If data
control SWC are detected by the interface, this mode will be automatically skipped.
C.
3 Chimes and both LEDs flash green:
Chime volume adjustment
This allows you to adjust the volume of the
chimes generated by the interface using the adjustment dial on the side (this mode is not available in vehicles
equipped with Premium Bose (Y91 / UQA) amps). If a Premium Bose amp is detected by the interface, this mode will
be skipped as the factory amp is what generates the chimes. Please see the vehicles owner’s manual for adjustment of
chime volume in vehicles with Premium Bose (Y91 / UQA).
D.
4 Chimes and LED 1 flash red:
Master reset
.
LED 1 will flash red
and you will hear four chimes. This does a master
reset of the interface and restores the following settings to factory defaults:
• SWC Mapping
• SWC Calibration
• Camera Settings
• Infotainment Settings
• Interface User Options
Alpine
JVC
Kenwood
Clarion
Pioneer
Sony
Fusion
Volume -
Volume -
Volume -
Volume -
Volume -
Volume -
Volume -
Volume -
Source Up
Source
Source
Source
Source
Source
Source
Source
Source Down
Band
Band
Mute
Band
Band
Band
Off
Seek Up
Track +
Track +
Track +
Track +
Track +
Track +
Seek Down
Track -
Track -
Track -
Search -
Track -
Track -
Track -
Voice
OnStar
OnStar
OnStar
OnStar
OnStar
OnStar
OnStar
Prog
Preset Up
Preset -
Preset
Mute
Audio
