© 2024 Stinger. All rights reserved. PAC is a Power Brand of Stinger.
PAC-Audio.com
Pacific Accessory Corporation
Page 3
Rev: V1
Date: 020924
Advanced Subwoofer Amplifier Interface
for Select Chrysler / Dodge / Jeep / RAM Vehicles
APSUB-CH42
Setup and Configuration (cont.)
Active Noise Cancellation (ANC) Bypass
Vehicle
Vehicle
Amplifier Location
Amplifier Location
Jeep Gladiator
Jeep Wrangler JL
RAM Truck 2500+
Driver Side of Dash
RAM Truck 1500
Under Driver Seat
Chrysler Pacifica
Jeep Cherokee
Passenger Side of Dash
Dodge Durango*
Jeep Grand Cherokee*
Driver Side Rear Quarter Panel
When adding a subwoofer to a vehicle equipped with
ANC, the ANC system will attempt to cancel out the bass
frequencies being generated by the aftermarket subwoofer.
This results in unwanted "noise" being produced by the
factory speakers.
Identifying ANC in the Vehicle
Vehicles with multiple microphones located in the door
panels or headliner locations will usually be equipped with
ANC. If you are unsure, the ANC-CH02 can be installed with
no negative effect on vehicles not equipped with ANC.
Bypassing the ANC Signal
1.
Access the factory amplifier (see location info to the right).
2.
Disconnect the 10-pin factory harness from the amplifier.
3.
Plug in the ANC-CH02 harness into the amplifier.
4.
Connect the 10-pin factory harness to the ANC-CH02.
TO AMPLIFIER
TO AMPLIFIER HARNESS
Setting the minimum volume using the programming button
1.
Start with the level control knob turned all the way down (counter-clockwise).
2.
Set the amp gains to the desired level.
3.
Set the volume on the factory radio to 1.
4.
Press the programming button on the side of the interface once.
5.
LED 1 will turn amber and the chimes will begin sounding every five seconds.
6. Turn the level control knob clockwise until the desired minimum volume level is reached.
7. You can now either press the programming button once or wait ten seconds to exit the settings.
Setting the minimum volume using the factory dash panel controls
1.
Start with the level control knob turned all the way down (counter-clockwise).
2.
Set the amp gains to the desired level.
3.
Set the volume on the factory radio to 1.
4. Press and hold the track down button on the factory SWC (Back left of steering wheel) for approximately ten seconds.
PLEASE NOTE: The radio will respond to the SWC commands during this process, this is normal and has no effect on
the APSUB operation.
5.
LED 1 will turn amber and the chimes will begin sounding every five seconds.
6. Turn the level control knob clockwise until the desired minimum volume level is reached.
7. You can now wait ten seconds to exit the settings.
*On some Grand Cherokee and Durango models, the vehicle may be equipped with a factory amplifier and a separate
ANC module and the ANC-CH02 will not fit into any connector on the amplifier. In which case, the ANC-CH01 harness (sold
separately) would need to be installed at the ANC module behind the Passenger Side Rear
Quarter Panel to deactivate the
ANC system.
Note: Some models are not included in this table because
ANC is not an available option for those vehicles.
Common Trim locations listed: Some trims may be located
elsewhere in vehicle.
PLEASE NOTE: Level control knob must be connected to module for either of the following methods