© 2017 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
Pacific Accessory Corporation
Page 3
Rev. 070717
Advanced Amplifier Interface
for Ford / Lincoln
AP4-FD11
Testing and Verification (cont.)
Setting the chime volume using the programming button
1. Start with the level control knob turned all the way down (counter-clockwise).
2.
Press the programming button on the side of the interface.
3. LED 1 will turn green and the chimes will begin continuously sounding.
4. Turn the level control knob clockwise until the desired chime level is reached.
5.
You can now either press the programming button twice or wait ten seconds to exit the settings.
Setting the chime volume using the factory Seek/Track button (Only available in vehicles with factory center stack
radio)
1. Start with the level control knob turned all the way down.
2.
Press and hold the Seek/Track down button on the factory radio for approximately ten seconds.
PLEASE NOTE:
The radio
will respond to the commands during this process, this is normal and has no effect on the AP4 operation.
3. LED 1 will turn green and the chimes will begin continuously sounding.
4. Turn the level control knob clockwise until the desired chime level is reached.
5.
You can now either press the programming button twice or wait ten seconds to exit the settings.
Manually Setting the Minimum Volume
If the minimum volume of the radio (factory radio volume level 1) is too loud, you can manually set the level of the minimum
volume using either the programming button on the side of the interface or the factory seek / track buttons. If you would like to
set the minimum volume using the AmpPRO app, please proceed to the AmpPRO App section.
PLEASE NOTE: Level control knob must be connected to module for either of the following methods.
Setting the minimum volume using the programming button
1. Start with the level control knob turned all the way down (counter-clockwise).
2. Set the amp gains to the desired level.
3. Set the volume on the factory radio to 1.
4.
Press the programming button on the side of the interface twice.
5.
LED 1 will turn amber and the chimes will begin sounding every five seconds.
6. Turn the level control knob clockwise until the desired minimum volume level is reached.
7.
You can now either press the programming button once or wait ten seconds to exit the settings.
Setting the minimum volume using the factory Seek/Track button (Only available in vehicles with factory center stack
radio)
1. Start with the level control knob turned all the way down (counter-clockwise).
2. Set the amp gains to the desired level.
3. Set the volume on the factory radio to 1.
4.
Press and hold the track up button on the factory SWC for approximately ten seconds.
PLEASE NOTE:
The radio will
respond to the SWC commands during this process, this is normal and has no effect on the AP4 operation.
5.
LED 1 will turn amber and the chimes will begin sounding every five seconds.
6. Turn the level control knob clockwise until the desired minimum volume level is reached.
7.
You can now either press the programming button once or wait ten seconds to exit the settings.
Use of the AmpPRO App allows
you to do the following:
•
Configure User Interface Options such
as:
•
Minimum Volume Level
• Chime Volume Level
•
Enable / Disable AP4 Chimes
• Enable / Disable factory EQ
• Bass / Treble boost frequencies and
Q factor
•
Update Product Firmware
•
Read Firmware / Hardware Versions
•
You can download the Amp PRO app at :
http://aampglobal.com/appdownloads
AmpPRO App
