GENERAL & SAFETY INFORMATION
GENERAL INFORMATION
The maximum pressure of the compressor is
0
-100
PSI . The maximum operating pressure while spraying will vary
depending on size of fluid tip, needle and aircap.
THERMAL PROTECTOR
The motor of this compressor has
a thermal overload protector. If the
motor should overheat, the
overload protector will shut off the
motor. If this should occur, unplug
the compressor and allow the motor
to cool (approx. 5 minutes) and
restart compressor.
SEALING OF AIR HOSE
When attaching the female pipe
thread fitting from your air hose to
the compressor use PTFE pipe
thread tape
(Included)
on the
Male
quick connect
. Failure to do so may
cause an air leak and your
compressor will not shut off as it
should. NOTE: This unit does not
require any lubricants or oil. Applying
oil to any part could result in
damage
to the compressor. All bearings,
including those in the motor, are
grease packed.
AUTOMATIC SHUT-OFF FEATURE
This compressor has a built-in
pressure switch that automatically
shuts-off the compressor when the
tank is full. It will immediately start
again as soon as the tank reaches the
pre-set psi.
WARNINGS
• Only use 110-120 volt, 60 cycle power supply for this compressor.
• Before plugging in check to make sure compressor is in good condition.
• Only operate compressor in accordance with current safety regulations.
• Keep working area clean and uncluttered and make sure area is well ventilated. Never operate the compressor in the presence of
flammable liquids or gases.
• Compressor air can produce dust, dirt and loose particles it comes in contact with. To prevent possible injury always wear safety
goggles or glasses. Never point any nozzle or spray toward a person.
• The air compressor is powered by electricity. Like any electric device, if not used properly it can cause electric shock.
• Keep out of reach of children.
Suggested Accessories:
1)
QM-2/QM-4
manifolds. For
multiple
hose hook ups.
2) Hose adapter. If your hose has
a 1/8” NPT fitting get the HF-592.
For the opposite get HF-116.
3) A-194 Airbrush Holder
4)
Manufactured in China for Paasche
Paasche Airbrush Company
4311 North Normandy Avenue
Chicago, IL 60634-1395
Phone: 773-867-9191 • Fax: 773-867-9198
Website:
paascheairbrush.com
E-Mail: [email protected]
This compressor is CE Listed
Included male
quick connects
Air
Regulator
Tank pressure
gauge
Air outlet gauge
Muffler
Tank
Moisture
drain valve
Pull-
ON
.....Push-
OFF
AC-7 Airbrush Cleaning Brushes
