
Paasche D500 Air Compressor
No. -Part No.-Description
1.
D502
Front Cap
2.
D504
Head
3.
D505
Connecting Rod
4.
D506
Rod Cap
5.
D509
Top Valve Plate
6.
D510
Bottom Valve Plate
7.
D511
Diaphragm
8.
D512
Intake Reed
No.- Part No.- Description
9.
D513
Exhaust Reed
10.
D514
Top Plate Gasket
11.
D515
Valve Plate Screw (8)
12.
D516
Reed Screw (2)
13.
D517
Head Screw (6)
14.
D518
Cap Retaining Screw (2)
15.
D519
Stator Screw (2)
16.
M-44
Counter Weight Screw
No.- Part No.- Description
17.
D521
Cap Split Lock Washer (4)
18.
D523
Rod Screw (2)
19.
D524
Rubber Foot (4)
20.
D525
Plug Bushing (2)
*
21.
D526
Motor Stator 115V., 60 Cy.
22.
D528
Electric Cord
23.
D529
Insulated Crimp Connector (2)
24.
D530
Ground Wire Screw
No.-
Part No.- Description
25.
D535
Bleeder Valve
26.
D539
Cord Strain Relief
27.
D540
Counter Weight & Rod Brg. Assy.
28.
D541
Rear Cap & Brg. Assy.
29.
D501
Housing Painted w/Bearing
*
30.
D543
Shaft, Rotor & Fan Assy.
* These items require factory installation!
SERVICE: Before returning D500 unit for service carefully read
and follow instructions. Disconnect before servicing.
If compressor should begin to pump less air, check six Head Screws
#13 and tighten if necessary. Check Exhaust Reed #9 and Intake Reed
#8 for damage and proper position over holes in Valve Plates #5 and
#6. When replacing parts, make sure to reassemble properly. Normal
operating temperature of compressor is 150°- 160°F.
Any electrical
servicing should be done by the Factory.
AUTOMATIC THERMAL LIMITED
The D500 Compressor will shut off automatically when overheated. To
restart, release air pressure and let Compressor cool down.
D500 Less On/Off switch is CSA Approved.
D500S With On/Off switch is not CSA Approved.