7 |
P a g e
Wiring
A typical wiring diagram is shown in figure 3.
Figure 3. Wiring diagram. All outputs in this example are used to switch
line voltage on the same phase. Since the outputs provide dry contacts,
any voltage that doesn’t exceed the specifications can be switched.
After installation, check if the outputs can be toggled via the inputs (only
applicable if input power is connected across terminals 43-44.) The status LEDs
will assist you in tracking the status of the outputs and see if the inputs are
working properly.
Recommended wire types
Ethernet cable: Twisted pair, CAT5 or better.
Outputs: According to the load attached to the outputs (current and voltage
ratings).
Inputs: A pair of low or high voltage cable. The inputs use low voltage signals.
