P5 Kft.
2014
www.futurenow.hu
_____________________________________________________________________________________________
FutureNow FNIP-4xSH Installation Manual rev 15.01.2014
9
St LED
This status LED indicates that the bootloader of the module is active. This should only
happen during firmware update.
Please never disconnect power from the module while this LED is on!
If this LED stays on after the firmware update, please contact your distributor!
CONFIGURATION
Configuration can be done either via the built-in website or via TCP/IP connection. In the
latter case the configuration interface the controller provides is used.
Configuration via the web interface
Use the FNIP Network Discovery Utility software to find all FutureNow IP devices on your
network.
Connecting to the module’s web site
After the scan is over you can click on one of the modules found to open its website in a
browser.
You can also access the module’s internal web pages from an Internet browser by typing
FNIP4xSH
(default hostname) or whatever the hostname has been changed to or the IP
address in the URL window.
Each module automatically obtains an IP address from a DHCP server by default. In the lack
of DHCP server the default IP address of 192.168.1.25 will be assigned. The same IP
address will be assigned when connecting the module directly to your computer (not running
a DHCP server) with an Ethernet cross cable.
Authentication
Once you are connected to the module’s web site you will be asked to identify yourself, as
seen in figure 5.
