![background image](http://html1.mh-extra.com/html/p-r-c/lq-h001a/lq-h001a_user-manual_744968009.webp)
Operating Instructions:
There are 3 controls need to be paid attention.
The first is the valve on the cylinder, which will be used to turn ON and OFF the gas supply.
The second is the gas control knob with a dial which has 3 positions marked on it.
This control knob is located on the top end of the heater
(
fig4
)
The third is the piezoelectric ignition button next to the gas control knob
(
fig4
)
.
Pressing this button will generate a spark on the pilot burner thus igniting the gas to the pilot burner.
The pilot and center burner should remain alight.
You may now adjust the heater setting to LOW/ Med/ High as required.
Installation
1.
Put the cylinder into the gas heater
2.
Install the protection baffle to make sure the cylinder can't move
3.
Connect the pipe to the gas valve with cap
(
make sure no leakage)
4.
Connect another side of the pipe to the regulator with cap (make sure no leakage)
5.
Open the gas tap before using the heater, and close the gas tap after using.
Lighting heater:
Before connecting the regulator to the gas cylinder, check whether there is a rubber washer on the regulator and the
washer must be in good condition.
Connect the regulator to the gas cylinder by turning the handwheel anticlockwise.
Open the gas cylinder by turning the gas cylinder valve anticlockwise. Turn the gas control knob on the heater to
setting1 (fig 4).
Press the control knob down and hold in the pressed condition. This will allow gas to flow to the pilot and center
burner.
While holding the control knob in the pressed position push the piezoelectric ignition (fig 2 ) button 2 or 3 times.
Each time you strike this piezoelectric ignition you will hear a clicking sound as well as see a spark on the pilot
burner.
Once the pilot has lit, continue holding the gas control knob in the pressed position for a further 10 to 15 seconds
thus activating the flame failure safety device.
Turning off the heater
:
To turn off the heater, turn the control knob to position 1 and close the gas cylinder valve by turning the knob on the
cylinder clockwise. Ensure that the pilot flame and the center burner are extinguished.