2
MAN 9062624 EN V2
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: 70212626
DK-6600 Vejen
e-mail: [email protected]
Caster installation (picture 2)
Lay cabinet down on its back. Use packaging material to protect the paint finish.
Please mount both swivel casters on the same side of the Roller Cabinet as the side
handle. Each caster uses four M8x20 screws. Tighten the screws with a wrench.
To remove drawers ( picture 3)
Pull drawer out until it is almost fully extended.
Push down on the right hand black release lever, while pulling up on the left hand
black release lever.
Hold the levers in positions as instructed above, then pull the drawer outward until it
is released from the drawer slide.
To replace drawers
Extend the drawer slides from the cabinet.
Insert the brackets on each side of the drawer into the slots in the cabinet slides. (Be
careful that the drawer brackets are in their proper position.) Once the drawer
brackets are properly inserted, completely close the drawer to set the slides in their
proper positions.
We reserve the right to change the technical parameters and specifications of this product without prior notice.
