11
MAN 9061374 EN V2
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tlf: 70212626
DK-6600 Vejen
e-mail: [email protected]
Problems & solutions
Problem
Cause
Solution
The shredder does not
perform properly: the
wood
is not pulled in by the
machine itself. The chips do
not have the same size.
-The
blades are
worn
too
much
-The
diameter of the
branches inserted into
the machine is too
large
-There
is too big a gap
between the fixed blade
and the counter blade:
correct gap is 0.5 mm
(half a millimeter)
-Change or sharpen the blades
and counter-blade. Note that
the blades are sharpened on
both edges so they can be
reversed.
-Shut the engine off and remove
the branch that is too thick
-Adjust the gap between the
blade
and the counter-blade by
moving the counter-blade in the
slots
The engine does not start/
the engine shuts off by itself
-Electrical
problem
with
the engine
-No
fuel
-No
or not enough oil in
the engine (the oil
should be level
with
the
threads of the filler
hole.)
Check that
-The input tube is correctly fitted
and the bolts are tight
-Put the start-s
w
itch of the
engine
"
On
"
-De-activate the emergency
switch (turn the knob)
-Check oil and fuel levels
-Contact
your
dealer
lmportant: Screw back the blade
bolts.
The rotor jams
The engine
w
ill not
start/turn because the rotor
is jammed.
-the
diameter of the
branch is too big
-there
are unacceptable
materials such as
stones or metal in the
input tube
-a length of branch
remains in the rotor
after the engine
w
as
last stopped.
-shut off the engine
,
remove
the spark plug cap and turn
the rotor counter-clock-
w
ise.
Use a
w
ooden stick to turn the
rotor and to remove the
material from the rotor and
input tube
.
lf necessary
,
remove the cap of
the bearing housing and rotate
the rotor axle
w
ith a spanner.
lf necessary
,
remove the input
or output tube to facilitate
access to the rotor.
Check the sharpeness of the
blades and counter blade and
replace them if necessary.
lmportant: Scre
w
back the blade
bolts
.
