10
MAN 9059510 EN V2
P. Lindberg A/S
Sdr. Ringvej 1
www.p-lindberg.dk
Tel.: +45 70212626
DK-6600 Vejen, Denmark
E-mail: [email protected]
The chains have been
factory adjusted so that
the lifting arms can swing
in and out without
touching the floor.
It may be necessary to
finely adjust the length of
the chains.
•
Raise the carriages.
•
They will then sink
down on the safety
locks.
•
If adjustment is
required, use the
adjustment bolt.
Checks that should be carried out after fitting and after using the automotive lift for
the first time:
No.
Check
Yes
No
1
Are both columns vertical?
2
Are the columns parallel?
3
Are the oil hoses fitted correctly and tightened?
4
Is the expansion bolt tightened to 18 kpm/180 Nm?
5
Are the lifting wires fitted securely?
6
Are the lifting arms attached securely?
7
Are the lifting arms’ locking mechanisms adjusted
correctly?
8
Are the electrical connections connected correctly?
9
Are all moving parts lubricated?
10
Are chains and wire lubricated with grease (
must
be done
) ?
Use
3.1
Different cars have different balance points. Before lifting the vehicle, you must find its correct
balance point in order to position the vehicle in the right place between the columns.
Chain guard
Adjustment bolt
Securing nut
