R2 05/03
SPECIFICATION / REPLACEMENT PARTS
GLUEBOARD REPLACEMENT
BEFORE REPLACING THE GLUEBOARD, ALWAYS ENSURE THAT THE UNIT IS DISCONNECTED FROM THE
MAINS SUPPLY.
The glueboard should be replaced every month with a genuine
glupac
®
glueboard. Use of
non-approved glueboards may invalidate your guarantee. IND35
comes supplied with discreet
black glueboards with printed grids for simple insect evaluation and monitoring.
To replace the glueboard…
1. Swing the front guard open.
2. Remove the protective release paper from the new
glupac
®
glueboard.
3. Position the top of the
glupac
®
glueboard in position behind the two locating pins,
then carefully drop the horizontal face of the board into position.
Always ensure the selected genuine
glupac
®
glueboards are compatible with your unit,
available from your pest control operator or P+L Systems Ltd.
TUBE REPLACEMENT
TUBE REPLACEMENT SHOULD BE CARRIED OUT BY SERVICE PERSONNEL ONLY, AFTER ENSURING THAT
THE UNIT IS DISCONNECTED FROM THE MAINS SUPPLY.
To ensure the efficiency of IND35 in catching flying insects, the Synergetic
®
tubes should be
replaced annually. After twelve months the phosphor coating that emits the correct wavelength
of UV light has burnt away and the UV output is diminished substantially.
To replace the UV tubes…
1. Swing the front guard open.
2. Gently rotate the tube through 90º.
3. Pull the tube forward until it becomes free from the tube holder.
4. Reverse the process with the new Synergetic
®
tube.
5. Dispose of the used UV tubes in conjunction with local regulations.
STARTER REPLACEMENT
STARTER REPLACEMENT SHOULD BE CARRIED OUT BY SERVICE PERSONNEL ONLY, AFTER ENSURING
THAT THE UNIT IS DISCONNECTED FROM THE MAINS SUPPLY.
The starters provides an extra spark to initially light the UV tubes. Starters wear out and should be
replaced at the same intervals as the UV tubes.
To replace the starters…
1. Swing the front guard open.
2. Rotate the starter anti-clockwise.
3. Pull the starter free from the unit.
4. Reverse the process with the replacement starter.
Unit
IND35
Voltage
230V ~ 50Hz
Dimensions(mm) 470 x 230 x 130
Coverage
80 Sq. Meters
Weight
5.0Kg
Light Output
30W
Tubes
2 x TGX15-18S
Starter
2 x I154
Glueboards (x6) INF212
(Black)
Starter Replacement
Glueboard Replacement
1
2
P+L Systems
Sterling House
Grimbald Crag Close
Knaresborough
North Yorkshire
HG5 8PJ
UK
T +44 (0)800 988 5359
F +44(0)1423 863 497
W www.pandlsystems.com
WEEE Compliance No. 01576542
C
2013
P+L Systems Ltd
Information provided on these instructions is modified and
updated from time to time. This is due to the constant
redevelopment of our products. As such, it is not intended that
you should rely on it or that it should form part of any contract.
Tube Replacement
