8
STEP 2: COMPLETE ELECTRICAL CONNECTION
1
Install female connector (supplied) to end of
power cable (refer to section 6.1)
2
Once connection is complete, push the female
connector into the male connector on the end of
the fixture until firmly engaged.
WARNING
Ensure that the strain relief is properly fitted.
The contact can become damaged and water
ingress problems may arise if this is not the case.
3
Switch on the mains voltage.
ATTENTION
In the event that multiple fixtures are mounted
consecutively, the distance between each
fixture must be a minimum of 4 in. (10 cm)
10 cm
10 cm
4 in
(10 cm)
4 in
(10 cm)
5
INITIAL STARTING
Switch on the mains voltage as a function test. See
Section 7 Troubleshooting if the fixture fails to light up.
6
MAINTENANCE, ENVIRONMENT
AND DISPOSAL
WARNING
• Switch off the mains voltage before commencing
maintenance work.
• Do not open or disassemble the product. Opening the
product can prove hazardous and will void the warranty.
ATTENTION!
In the event that the product is defective or damaged,
contact the dealer from whom you purchased the
fixtures, or PL Light Systems directly. Never switch on
a defective or damaged fixture.
• Check the product at regular intervals for build-up
of dust and dirt. Clean the product if necessary.
Contamination can lead to overheating and reduced
performance.
• Clean the fixture with a dry or slightly damp cloth.
Ensure that the glass lens (section 2.2, #2) is
always clean.
ATTENTION!
• Never clean the product with corrosive cleaning
agents, abrasives or other aggressive liquids.
• Protect the male end of the Wieland connector
(section 2.2, #1) against the ingress of water when
no female connector (section 2.2, #6) is attached.
• Only use a vinegar and water solution (1:100 ratio)
to remove build-up of limescale on the lens.
• In the event that the product is stored, it must be
kept in a dry, clean environment with an ambient
temperature of -20 ~ 50°C
• This symbol on the material, accessories
or packaging indicates that this product
may not be discarded as household waste.
Dispose of the equipment through a
recycling centre that handles electronics
and electrical appliances within Canada
and the United States of America which
use separate collection systems for used
electronics and electrical appliances.
By disposing of the equipment in the
proper way, you will be helping to prevent
possible risks to the environment and
public health, which might otherwise
be caused by improper handling of
the discarded equipment. Recycling of
materials contributes to the conservation
of natural resources. Therefore, please do
not dispose of your old electronics and
electrical appliances via household waste.
