P.I.T. PJF20H-250A, Manual

Page: 6 / 20

Cordless Jobsite Fаn
5
Contents of delivery
Battery fan 1 PC.
Network adapter 1 PC.
Manual 1 PC.
Note
The text and numbers in this manual may
contain technical errors and typographical er-
rors.
Since the P.I.T. is constantly improving, the
company reserves
the right to make changes to the specifica-
tions and equipment specified here without
prior notice.
Exploitation
WARNING
• Avoid carelessness caused by a good
knowledge of the instrument. Remember
that a second of inattention is enough to
cause serious injury.
• Do not use any batteries, accessories,
or attachments not recommended by the
manufacturer of this instrument. Use of
non-approved batteries, accessories, or
attachments could result in serious injury.
• Do not handle the cord and battery with
wet or oily hands.
• Never use the cordless fan with a dam-
aged cord or plug.
• Do not leave the AC adapter disconnected
from the battery fan while the AC adapter
is plugged in.
Small children may place a live plug in their
mouths, which could cause injury.
• When inserting / removing the battery or
connecting / disconnecting the AC adapter,
be sure to place the battery fan on a fl at,
stable surface.
This fan is equipped with a 3-speed con-
trol with a speed selector.
Power source can be AC adapter or re-
chargeable battery (not included)
Using a network adapter
Connect the plug of the power adapter to the
fan. Then plug the adapter into an electrical
outlet.
Make sure the rated voltage of the mains sup-
ply matches the rated voltage of the adapter.
ATTENTION!
The supplied AC adapter does
not charge the battery inserted in the battery
fan.
Using the rechargeable battery
Charging the battery (fi g. A)
1) Connect the charger to the appropriate
the corresponding outlet. The green indicator
will light up.
2) Insert the battery into the charger, the indi-
cator will turn red, indicating that the charging
process has started.
3) When charging is complete, the indica-
tor will turn green. When the battery is fully
charged, unplug the charger and remove the
battery.
WARNING: when the battery runs out of pow-
er after continuous use,
exposure to direct sunlight or heat, allow time
to cool before recharging to achieve a full
charge.
Removing and installing the bat-
tery pack (fi g. B)
WARNING: before removing or by installing
the battery pack fromunplug the device.
1) Press the battery release button to release
and slide, remove the battery from your tool.
After recharging, insert it back into
connector on the back of the fan until you
hear a click. A simple push and a little pres-
sure will suffi ce.
Do not use force when inserting the bat-
tery cartridge. If the cartridge does not
slide in without force, it will not install cor-
rectly.
Carrying handle
Carry the fan using the top handle (4).
Note: do not move the fan until it stops
completely.
Hanging hook
The integrated hanging hook can be used to
hang the fan.
WARNING:
• Never suspend the cordless fan in high
places or on surfaces where the tool could
become unbalanced and fall over.
• Use strong, resistant materials to hang the
battery fan.
Airflow Direction Adjustment An-
gle
The angle of the fan head can be adjusted.
Head movement range: minus 45 degrees to
180 degrees. (-45 to 180 degrees) (see fi gure
C1)
Switching off the fan (fi g. D)
Turn the knob so that the arrow points to No. 0,
the fan will turn off .
Fan speed changeover
Turn on the fan by turning the knob
switch so that the arrow points to No. 1 - low
speed (see Fig. E1), in the same way you can
turn on higher speeds No. 2 and No. 3 (see
Fig. E2 and E3).