F o r m X X X X : R e v i s e d A u g u s t , 2 0 1 5
Page 4
should be inspected and tested no less than weekly to determine the condition of the machine. Necessary
maintenance or repair of both shall be performed and completed before the machine is operated. The
EMPLOYER shall maintain records of these inspections and the maintenance work performed.
Our Company is not responsible to notify the user of this equipment of future changes in State or Federal
laws, or construction
standards.
1.3
Warranty Program
We warrant our new parts against defects under normal use and service for a period of 12 months after date
of shipment. Our obligation under this warranty is limited to replacing or repairing (at our option) the
defective part without charge, F.O.B. our plant in Bloomfield, Connecticut. The defective part must be
forwarded to our plant, freight prepaid, for our inspection prior to replacement or repair
. EXCEPT AS
EXPRESSLY PROVIDED HEREIN, THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS OR
IMPLIED, INCLUDING A WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
Furthermore, the seller does not warrant or represent that the equipment complies with the provisions of any
law, particularly including the Occupational Safety and Health Act of 1970, and regulations promulgated there
under. In no event shall we be liable for special, indirect incidental or consequential damages, however rising.
1.4
Receiving and Inspection
SPECIAL NOTE
: P/A INDUSTREIS INC. ASSUMES NO RESPONSIBILTIY IN CONNECTION HEREWITH, NOR CAN IT
BE ASSUMED THAT ALL ACCEPTABLE SAFETY MEASURES ARE CONTAINED IN THIS PUBLICATION, OR THAT
OTHER ADDITIONAL MEASURES MAY NOT BE REQUIRED UNDER PARTICULAR OR EXCEPTIONAL
CIRCUMSTANCES OR CONDITIONS.
2
Installation and Assembly
2.1
Mechanical
The reel is designed for either permanent mounting or portability from the press line to press line. It can be
positioned on its adjustable machine mounts or firmly bolted to the floor through the four holes provided in
the base. With the use of lockable casters, the reel can easily be moved to various locations in your facility.
The reel should be placed on the exit side of the press for rewind applications. When the location is chosen,
the reel should be placed so the backing plate is in line with the Pass-Line of the press. Enough room should be
provided between the press and reel to allow for placement of the appropriate loop control device.
RECEIVING INSPECTION
Before removing the unit from its packaging, check for visual damage, especially if crate, skid,
or carton had been damaged in transit. Any damage caused by shipping should be immediately
reported to the carrier. If the unit appears in satisfactory condition, remove all the packaging.
Read these instructions. They are provided to answer questions regarding the Operation and
use of this equipment.
