Form 1189 SRF-48 ROLL FEED 4/1/2009
6
FIGURE 3A
2.
Adjust for the material thickness using the (2) Cylinder Thickness Adjustment dials. Adjust the dials to the
required setting for your material. (0-3mm range) Refer to the
FIGURE 3A
for proper setting
3.
Open the feed rolls by selecting
Open
on the jog pendant. Insert the material through the feed rolls and close
the feed rolls by selecting
Close
on the jog pendant.
4.
Using the
Jog Forward
button on the jog pendant, advance the material up to the entrance of the die (far
enough where the punches would not pierce the material).
5.
Check the vertical alignment of the strip. If necessary, adjust the pass line of the feeder so that the material is at
the proper height.
6.
Assuming that the press shut height and the tool are set up properly, jog the press one or two strokes without the
feed working.
7.
Jog the press down slowly observing when the longest pilot would engage the pilot hole in the material if the
material were there. (Refer to Figure 4.) Note the press positional readout and put this setting into your
Programmable Limit Switch (PLS) for the ‘
Pilot Release On’
setting. The ‘
Pilot Release Off’
setting, in most
cases, should be 180º. (See Figure 5.) Some drawing applications require the rolls to remain open past 180º.