7
INSTRUCTIONS TO FIT OPTIONAL
OZTRAIL GAZEBO ACCESSORIES
You will require 4 wall kits to enclose
the entire 2.1 x 2.1m Freestyle Gazebo,
2.4 x 2.4m Compact Gazebo, 3.0 x 3.0m
Deluxe Gazebo and 6 wall kits to
enclose the 4.8 x 2.4m Compact
Pavilion, 6.0 x 3.0m Deluxe Pavilion.
You will require 4 wall kits to enclose
the entire 4.5 x 4.5m Deluxe King
Gazebo and 2 wall kits to enclose the
4.5m walls on the Mega Gazebo and
Mega Pavilion.
On some Gazebo models the walls will
not touch the ground when the Gazebo
is set to the maximum height.
-
-
-
WALL KIT ATTACHMENT
INSTRUCTIONS
HALF HEIGHT SOLID WALL KIT
ATTACHMENT INSTRUCTIONS
FREESTYLE GAZEBO WALL KITS ARE
SUITABLE FOR ALL 2.1m WALL LENGTH
MODELS.
COMPACT GAZEBO WALLS KITS ARE
SUITABLE FOR ALL 2.4m & 4.8m WALL
LENGTH MODELS.
DELUXE GAZEBO WALL KITS ARE
SUITABLE FOR ALL 3.0m & 6.0m WALL
LENGTH MODELS.
MEGA GAZEBO WALL KITS ARE
SUITABLE FOR ALL 4.5m WALL LENGTH
MODELS.
STEP 1:
Locate the top corner of the wall. The top of
the wall has a hook sewn into each corner and
Velcro patches along the outside edge.
STEP 2:
Using the hooks, connect each of the top
corners to the metal ring located at the top of
the Gazebo leg, then attach the Velcro from
the wall to the Gazebo.
STEP 3:
Peg down each side of the wall kit using
the pegs provided.
STEP 4:
Tie the wall kit to the legs of the Gazebo
using the ties located about halfway up
each side of the wall kit.
STEP 1:
Assemble the 3 section pole and slide it
gently through the pole sleeve that runs
along the top of the wall.
STEP 2:
Using the claps at each end the pole,
connect the claps firmly but not tight to
the leg upright at approximately halfway
up the leg. Checking the hooks on the
bottom corners of the wall can reach and
attach to the leg feet.
STEP 3:
Now attach the hooks to the feet and
gently re-adjust the claps to make the wall
sit secure and neatly. Make sure the claps
are firm but not tight.
STEP 4:
Locate the Velcro tabs on the wall, found
just below the pole claps. Secure the wall
kit to the legs of the Gazebo using these
Velcro tabs.
STEP 5:
To add another wall kit, zip it to the
existing wall and repeat the above steps.
