15
Figure 24
Figure 23
Step 5 Peg out the Camper
Trailer Tent
Step 6 Camper Trailer
Tent frame adjustment and
assembly
Close the doors completely. Peg out the corners
of the Camper Trailer Tent. For peg point
locations, see Figure 23. Anchor the tent to the
ground by inserting the pegs through the loops
around the base of the tent at an angle of 45
degrees, firm but not tight, see Figure 24. Start
with the corner peg points along the trailer edge.
As you work from one peg point to the next
around the tent base pull the floor firm, but not
tight. Ensure all peg down points are utilised
and where applicable the length of the webbing
loops is correctly adjusted.
Check again the trailer is level and secure, by
repeating Step 1 above. Now unzip the door
access under the awning and walk inside the
Camper. Note that the steel hoop pole frames
radiate from hub plates at each front corner of
the timber base board.
During the first set up, it will be necessary to
adjust all the main hoop pole frames’ height and
tension.
Firstly, get up onto the bed platform and extend
the adjustable trailer side poles on each side
of the bed platform until they pull the front
wall up firmly, see figure 25. Next, extend the
adjustable centre side poles on each side of the
bed platform to pitch the roof firmly, see Figure
25 (page20) .
HELPFUL HINT
Apart from minor adjustments from time to
time these hoop pole frames above the bed
platform should not require regular tensioning
on future camping trips.
Set up and Assembly
Instructions
Peg Points
Please Note: two extra side pegs
points for C7 and four extra for C12 models
