TRANSPORTING, MOVING AND INSTALLATION
Heated unıts are be delivered as a standard in wooden cases, reinforced by EPS block,
wrapped with stretch film and air bubble protective packing, and wrapped over again with a
second layer of stretch film
The device may be moved with manpower.
Do not hit or drop the device when moving
CHANGING THE LOCATION;
Machines installed by an authorized service
CANNOT
BE
MOVED ELSEWHERE ITS POWER SUPPLY CABLES
Do not hit or drop the device when moving.
MOVED ELSEWHERE, ITS POWER SUPPLY CABLES
CANNOT BE EXTENDED OR REPLACED except by
an authorized service.
If this device located near to any wall, separation, kitchen furniture,
decorative coating etc. the distance in between should be 20 cm. and if those
are coated with fireproof heat insulating material, the distance should be 5 cm.
It is strong recommended that fire safety protection instructions are observed.
Remove stretch film on the device before installing the device.
After the device is moved to the location where it will be operated, rollers should be set to lock
position. In this way sliding of the trolley is prevented.
Power supply connection of the device should be checked by an eligible electrician, and it
should be connected to a fuse at a maximum height of 170 cm.
Power supply connection should be made using a 30 mA current leakage fuse as a protection
against current leakage danger.
Power installation of the plugs to be used should be grounded by connecting it to a grounding
bar at the nearest panel.
8/12
p
