FITTING
EN
12
11
Close the left hand flap, white loop 1 should be pulled through eyelet 2, and white loop A through eyelet B
The right hand flap can now be closed. White loop 1 should be pulled through eyelet 3 and white loop A through
eyelet C
Now the top flap can be pulled into position. The handle sits behind the exterior material of the top flap.
Pass the nylon pins of the reserve handle through the gaps in the material just above the top flap eyelets.
Pull the white loops through both top flap eyelets and push the pins through the white loops. The magnetic
section can be wrapped around the handle and secured behind it to keep it neatly in place.
Finally the ends of the nylon pins can be neatened into the available tunnel as shown.
Before your first flight, we recommend to suspend the harness from a suitably strong point to check that
it fits you correctly and to become familiar with the features and adjustments. You can set the shoulder
adjustment-straps to find the best fit, and adjust the lumber support so that they leave you in a comfortably
reclined position.
To put the harness on first place the shoulder straps over your
shoulders and bring the leg/chest strap through your legs.
Fasten the leg/chest strap by placing the male buckles
through the female
through the female buckles on each side
The automatic pod closing system should now be
connected. First attach the red loop of the left hand pod
flap to the red ball situated under the maillon on the right
hand side of the harness. The red ball goes through the
red loop.
