SET-UP
APEX V1 BOARD USING TITANIUM T-NUT
DECK WASHERS:
1: Fit the 4x T-Nut Deck Washers into the board slots.
2: Fit the 4x T30 28mm Custom Titanium Screws into the T-Nut Deck
Washers. Turn each screw one full rotation to get the thread started.
3: Slide the screws and washers to the ends of the board slots.
4: Place the mast on the board and align the slots.
5: Slide each screw into the slot on the mast, ensuring the T-Nut Deck
Washers remain connected.
6: Slide the screws until they fit at the countersunk section of each slot
on the mast.
7: Firmly hand tighten each screw (approx. 8N.m torque wrench setting)
MAST TO BOARD
FUSELAGE TO MAST
OTHER BOARDS WITH US BOX USING M6 T-NUTS:
1: Assemble the 4x T30 28mm Custom Titanium Screws with the T-Nuts.
Turn each screw one full rotation to get the thread started.
2: Fit the screw and T-Nuts into the US box.
3: Slide the screws and T-Nuts to the ends of the tracks.
4: Place the mast on the board and align with the tracks.
5: Slide each screw into the slot on the mast, ensuring the T-Nuts remain
connected.
6: Slide the screws until they fit at the countersunk section of each slot
on the mast.
7: Firmly hand tighten each screw (approx. 8N.m torque wrench setting)
1: Fit the Fuselage onto the Mast tuttle.
2: Push the Fuselage down until the fit feels snug and
it can not be pushed further.
3: Align the 2x T30 22mm Custom Titanium Screws
with the Barrel Nuts inside the Mast and begin to
tighten. Ensure the screws are threaded correctly.
4: Tighten each screw a few turns at a time so they
tighten evenly and slowly pull the Mast tuttle into
the Fuselage.
5: Firmly hand tighten each screw (approx. 8N.m
torque wrench setting)
FRONT WING TO FUSELAGE:
1: Fit the Front Wing onto the Fuselage.
2: Align the 2x T30 **mm Custom Titanium screws with
the Barrel Nuts inside the Fuselage and begin to
tighten. Ensure the screws are threaded correctly.
3: Tighten each screw a few turns at a time so they
tighten evenly.
4: Firmly hand tighten each screw (approx. 8N.m torque
wrench setting)
**Refer to table on right for screw length.
REAR WING TO FUSELAGE:
1: Fit the Rear Wing onto the Fuselage.
2: Align the 2x T30 **mm Custom Titanium screws with
the Barrel Nuts inside the Fuselage and begin to
tighten. Ensure the screws are threaded correctly.
3: Tighten each screw a few turns at a time so they
tighten evenly.
4: Firmly hand tighten each screw (approx. 8N.m
torque wrench setting)
**Refer to table on right for screw length.
WING FRONT BACK
(LEADING EDGE) SCREW
(TRAILING EDGE) SCREW
MA210 16mm 16mm
MA315 22mm 16mm
LA1200 30mm 28mm
MA950 28mm 24mm
MA1100 28mm 24mm
MA1250 30mm 24mm
MA1500 30mm
28mm
MA1800 30mm
28mm
SCREW LENGTH GUIDE
