Turning On & Off
1. To start the tool press the on/
off switch forward into the on
position.
2. To stop the tool press the on/
off switch backward into the off
position.
WARNING!
AFTER USE, HOLD THE TOOL AWAY
FROM YOUR BODY UNTIL THE SPINDLE STOPS
COMPLETELY.
Note:
Hold the tool by the sure
grip handle. Your non-dominant
hand can also be used to steady
the tool on the by holding over the
accessory locking handle.
Variable Speed Control
1. To increase the speed of the tool, rotate
the variable speed dial to a higher
number.
2. To decrease the speed of the tool, rotate
the variable speed dial to a lower number.
2. ATTACHING ACCESSORIES
3. CONTROLS
OPERATION
Attaching Accessories
1. Rotate the accessory locking lever anti-
clockwise to open spindle fitment.
2. Place the desired accessory
onto the accessory drive spindle
ensuring the holes in the
accessory align with the notches
on the tool.
3. When using other non-Ozito multi function tool
compatible accessories, the accessory adapter
may need to be fitted to secure correctly.
4. Rotate the accessory locking
lever clockwise to secure the
accessory.
Note:
Pull on the accessory to
check if it is secured correctly.
WARNING!
KEEP FINGERS CLEAR OF SPINDLE
WHEN SECURING THE ACCESSORY TO AVOID
PINCHING.
Removing Accessories
1. To remove the accessory rotate
the locking lever anti-clockwise
and then remove from the
spindle.
10° - 15°
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
WARNING!
THIS PRODUCT IS NOT RECOMMENDED
FOR SANDING DRYWALL OR PLASTER DUE TO
THE ULTRA-FINE SANDING PARTICLES PRODUCED.
DRYWALL SANDERS IN CONJUNCTION WITH DUST
EXTRACTION ARE RECOMMENDED FOR DRYWALL
AND PLASTER SANDING APPLICATIONS.
WARNING!
ALWAYS WEAR GLOVES WHEN
HANDLING THE CUTTING ACCESSORY AS IT IS VERY
SHARP.
