ASSEMBLING THE FRAME
TABLE SAW
2000W 250mm
ASSEMBLY INSTRUCTIONS
PARTS
FASTENERS
1. Turn the table saw upside down
and place it on the floor (Ensure the
blade is wound fully down before
turning the saw upside down).
2. Remove the box of parts from behind the
motor; it can be easy accessed by tilting the
blade using the Blade Bevel Adjustment.
3. Attach the Base Frame Legs (A) to
the bottom of the table saw, you will
first need to remove the bolt and
washers from the table saw.
4. Ensure that the rectangular plastic cleats
on the table saw sit within the rectangular
slots at the top of the Base Frame Legs.
These cleats assist in support as well as
alignment. Use the bolts and washers
removed in step 3 to fasten all four legs to
the sides of the machine.
Note:
Only hand tighten at this stage, as some movement in the legs will
assist in aligning the cross struts.
5. When aligning the Cross Struts to the
Base Frame Legs, ensure that the
shorter edge is facing the table saw.
Note:
The Short Cross Struts (C) need to
be used on the sides of the table saw. Long
Cross Struts (B) front & back
6. Loosely fix the 4 Cross Struts to the
base frame legs, using the nuts, bolts
and washers supplied.
7. The Table Saw is supplied with 2
Stabilising Brackets. 2 bolts, 2 nuts
2 flat washers and 2 spring washers
are required to attach each bracket
to the bottom of the rear Base
Frame Legs.
8. Mount the Rubber Feet on the legs.
TSF-1211U
12. Bolt - 32 pc
13. Nut - 32 pc.
14. Washer, Flat - 32 pc.
15. Washer, Spring - 32 pc.
16. Spanner 10/13 mm
17. Spanner 10/21 mm
1. Legs (A)- 4 pc
2. Cross struts, long (B)- 2 pc
3. Cross struts, short (C) - 2 pc
4. Side table extension - 2 pc
5. Rear table extension - 1 pc
6. Feet - 4 pc
7. Dust extractor hose - 1 pc
8. Blade guard - 1 pc
9. Stabilising brackets - 2 pc
10. Support strut, side table - 4 pc
11. Support strut, rear table - 2 pc
1
12 13
7
6
9
10
8
2
3
4
5
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
11
14 15
16
17
WARNING!
BEFORE ASSEMBLING YOUR TABLE SAW
OR REPLACING BLADES, MAKE SURE THAT THE
MOTOR IS OFF AND THE TOOL DISCONNECTED FROM THE
POWER SUPPLY TO PREVENT ACCIDENTAL STARTING.
