WARNING!
ONLY USE THIS STAND WITH THE PROVIDED
MITRE SAW OZITO SCMS-10STAND. THE STAND MUST
NOT BE USED WITH OTHER PRODUCTS OR FOR OTHER
APPLICATIONS.
SCMS-10STANDU
11 Once all of the members are
joined together and all fasteners
are assembled, place the 4
mounting bolts into the holes
at the top of the stand. This
will ensure the mounting holes
align correctly while the stand is
tightened.
Tighten all nuts and bolts firmly.
Note:
We recommend that the stand
is mounted to a stable surface
for additional stability.
12 The Rubber Feet can now be
fitted.
13 Remove the mounting bolts that
you inserted prior to tightening
the stand, then place the saw on
the stand. The supplied mounting
bolts, spring washers, washers
and nuts should be used to
secure the saw to the top of the
stand.
6 Align one short lower support
inside the legs at the same height
as the long lower support. Ensure
that the lip of the side support is
facing up.
Insert 2 small bolts in the aligned
holes from the outside and
attaching a small washer, spring
washer and nut (only hand tight at
this initial stage).
7 On the same side as Step 6,
assemble one short upper support
to the top of the upper leg using
small bolts, washers, spring
washers and nuts.
One half of the frame is now
complete.
8 Repeat the same process for the
other side, which should leave
you with 2 identical halves.
10 Align the holes of each opposing
member. Bolts, washers, spring
washers and nuts can be inserted
& tightened with hand force only.
9 These halves can now be aligned
together to complete the frame.
Note:
Nuts & bolts should only be
finger tight at this stage.
