2. SDS
+
ACCESSORIES
3. FITTING AND USING THE DUST COVER
1 Slide dust cover over
accessory.
2 Add lubrication grease.
The cover catches dust and debris - while using the drill upright or
overhead - to avoid dust entering the air vents.
1 Prior to insertion into
chuck, ensure the SDS
+
accessory is clear of
dust and debris.
3 Pull locking sleeve back
and hold.
5 Rotate and continue to
insert as far as possible.
7 Checked SDS
+
accessory
is locked. Try to pull it out.
Note: It should have approx
10 – 20mm movement. This
is normal.
2 Prior to insertion into
drill add supplied
lubricant to the SDS
+
accessory.
4 Insert SDS
+
Accessory.
6 Release locking sleeve.
8 To remove the SDS
+
accessory pull back the
locking sleeve and pull
accessory out.
a
b
Accessory
SDS
+
3 Insert drill bit in locking
sleeve.
4 Press dust cover to the
end of locking sleeve.
