MAINTENANCE
• Remove build up of grass in the grass chute.
• Keep all safety devices, air vents and the motor housing free of dirt and
dust as far as possible. Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
• Do not clean the lawn mower with running water, particularly with high-
pressure water.
• Keep all nuts, bolts and screws tight to be sure the lawn mower is in a
safe working condition.
• Check the catcher frequently for wear or deterioration.
• Replace worn or damaged parts for safety.
• Only use the replacement blade and blade bolt specified for this product.
• Be careful during adjustments of the lawn mower to prevent entrapment
of the fingers between moving blade and fixed parts of the machine.
• When not in use, the mower should be stored in a dry, frost-free location,
out of reach of children. If the housing of the mower requires cleaning,
do not use solvents but a moist soft cloth and brush only.
• For best results, clean the lawn mower with a brush or rag.
Note: Ozito Industries will not be responsible for any damage or injuries
caused by the repair of the lawn mower by an unauthorised person or by
mishandling of the lawn mower. This tool is designed for DIY use - use in
commercial or industrial environments will void the warranty.
Cleaning, Maintenance and Storage
WARNING!
ALWAYS ENSURE THE LAWN MOWER
BLADE HAS COMPLETELY STOPPED, REMOVE
SAFETY KEY, BATTERIES AND GRASS CATCHER
PRIOR TO ANY MAINTENANCE.
For convenience, the handle can fold
down and the mower positioned for easy
cleaning and storage.
1. Sufficiently loosen the two handle
securing knobs located at the base of
the lower handles to allow the handle
assembly to fold forward.
2. Move the mower into the vertical
cleaning position.
3. Clean the bottom side of the mower
with the cleaning scraper.
NOTE:
The safety key and batteries must be removed and stored
separately from the mower.
Refer to the battery manual for battery storage.
TIMBER
Removing and Fitting the Blade
1. To remove the blade bolt, hold the blade firmly
and with a 13mm socket loosen the blade bolt
by turning it anti-clockwise.
NOTE:
A piece of timber will assist in holding
the blade while removing or tightening the blade
bolt.
2. Remove the blade bolt and blade.
3. To fit the blade, place the blade over the centre hole aligning the lugs.
4. Then retighten the fastening bolt with the universal wrench. The
tightening torque should be approx. 25 Nm.
CAUTION!
ALWAYS USE GLOVES WHEN HANDLING
THE BLADE. SHARP EDGES COULD CAUSE INJURY.
Replace the metal blade after 50 hours mowing or 2
years whichever is sooner. If the blade is cracked or
damaged replace it with a new one.
Only replace the blade with a genuine Ozito replacement blade, as this will
ensure top performance and safety under all conditions.
