1
2
P
-9
-6
-3
+3
P
1
2
1
2
P
-9
-6
-3
+3
P
1
2
PRESS
2. PREPARATION
WARNING!
ENSURE THE MACHINE IS SWITCHED
OFF AND THE BATTERIES ARE REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
Securing the Power Cord to the Handle
1. Secure the power cord from the
switch housing to the scarifier
using the three cable clips.
Note:
Ensure that the power
cord follows the handle smoothly
from the switch to the body of the
scarifier.
Adjusting the Scarifier Working Depth
The scarifier depth is adjusted with the depth adjustment lever.
1. Hold the depth adjustment lever
firmly as you pull inwards away from
the scarifier front wheel.
2. Adjust the lever to the required
position, ensure that the lever is
seated in place correctly.
Working height positions
+3
Transport po3mm
-3
Scarifier depth -3mm (shallowest)
-6
Scarifier depth -6mm
-9
Scarifier depth -9mm (deepest)
Inserting/Removing the Batteries and Safety
Key
Only use two 18V battery packs of equal
capacity and charge state. For best
performance use 2.5Ah batteries and above.
1. Open the battery cover and slide two
batteries of the same capacity and same
charge state into the scarifier, aligning the
ribs so that it clicks into place.
2. Insert the safety key. (If the scarifier is not
going to be used immediately, do not insert the safety key).
3. Carefully close the battery cover.
4. To remove a battery, open the battery
cover. Press and hold the battery release
tab as you remove the battery.
5. Carefully close the battery cover.
WARNING!
ALWAYS ENSURE THE KEY AND BATTERIES
ARE REMOVED WHEN NOT IN USE.
Fitting & Removing Grass Catcher (accessory)
This unit does not include a grass catcher. This is available separately.
1. Lift up the catcher flap on the rear of the scarifier with one hand and hook
grass catcher onto the housing from above.
2. Lower the catcher flap. The catcher flap is held against the catcher by a
spring.
3. To empty the catcher, lift the catcher flap with one hand, while unhooking the
catcher with the other.
WARNING!
ONLY FIT AND REMOVE THE GRASS
CATCHER WHEN THE SCARIFIER IS SWITCHED OFF AND
THE MOTOR HAS COME TO A STOP.
WARNING!
WHEN FITTING THE GRASS CATCHER AFTER
EMPTYING, ALWAYS ENSURE THERE IS NO BUILD UP
OF GRASS IN THE GRASS CHUTE.
Assembling the Grass Catcher (accessory)
This unit does not include a grass catcher. This is available separately.
1. Push both frame parts into each
other.
2. Pull the catcher over the catcher
frame.
3. Pull the rubber clips over the catcher
frame.
Handle Height Positions
1. Release the quick-release levers on
both sides of the scarifier housing.
2. Set the handle height to best suit
the user during operation, either
position
1 or 2 MUST BE
SELECTED.
3. Secure the quick-release lever to hold
the handle in the selected position.
Make sure that both sides are set to the same position.