MAINTENANCE
TROUBLESHOOTING
Battery protection system
The tool is equipped with the battery protection system, which helps to ensure a long service
life.
The output power automatically cuts off during operation when the tool and/or battery are
placed under the following situations:
• When the tool is overloaded:
If this occurs, release the trigger switch and remove causes of overload, then pull the
switch trigger again to restart.
• When the remaining battery capacity becomes low:
Recharge the battery pack.
Note:
The battery protection system does not in any way damage the tool.
Note:
The indicated capacity may be lower than the actual level during use or immediately
after using the tool.
LED lights do not illuminate on charger
Check the charging adaptor is securely plugged into the wall outlet.
Check the battery is firmly connected to the charging cradle.
Check that the charging jack is securely connected to the charging cradle.
The radio turns off after 4-5 hours
The battery pack may have gone into sleep mode, so turn power switch on & off, or check
battery power.
1.
When not in use, the radio should be stored in a dry, frost free location, keep
out of children’s reach.
2.
Keep ventilation slots of the radio clean at all times and prevent anything from
entering.
3.
If the housing of the radio requires cleaning, do not use solvents. Use of a
cloth only is recommended.
4.
Blow out the ventilation slots with compressed air periodically .
Note:
Ozito Industries will not be responsible for any damage or
injuries
caused by repair of the drill by an unauthorised person or by mishandling.
