5. FUNCTIONS
6. DRILLING
FWD
REV
3
5
7
9
Drilling
1 To drill into wood, metal or plastic,
turn the function collar to the align
the arrow on the housing with the
drill icon.
Screwdriving
Hammer Drilling
1 To screw into wood, metal or
plastic, turn the function collar to
the align the arrow on the housing
with the screw icon.
The clutch is then enabled to
adjust torque.
Note:
1st gear (low speed)
is recommended for
screwdriving.
1 To drill into concrete, brick or
other masonry, turn the function
collar to the align the arrow on
the housing with the hammer
icon.
Note:
2nd gear (high speed) is
recommended for hammer
drilling.
PXHDK-200U
Before starting to drill, perform a few simple checks.
3 Secure the material to be drilled in a vice or clamp to stop it turning whilst
drilling.
1 Depress and release the variable
speed trigger to ensure it is not
locked on.
4 Hold the drill firmly and place the
bit at the point to be drilled.
2 Check the function selector
and forward/reverse lever is on
desired setting.
5 Depress the variable speed
trigger to start the drill.
6 Move the drill bit into the workpiece.
Note:
Do not force the drill or apply side pressure to elongate the hole. Let
the drill do all the work.
2 To adjust the torque, rotate the torque collar to the desired setting.
Note:
Selecting a higher torque setting will allow the drill to use more torque to drive
the screw in or out. To prevent damaging the screw head, it is recommended to
start at a low torque setting and increase when necessary.
