ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
21
19
17
LOCK
LOCK
LO
CK
1.
Straight Chuck
2.
Keyless Locking Collar
3.
Integrated Hex Driver
4.
Torque Collar
5.
Variable Speed Trigger
6.
Forward/Reverse Lever
7.
Gear Selector
8.
Accessory Holder
9.
LED Worklight
10. Right Angle Chuck
11. Offset Chuck
This tool is compatible with all batteries & chargers from the Ozito Power X Change
range.
CORDLESS MULTI--CHUCK DRILL
BATTERY & CHARGER
KNOW YOUR PRODUCT
1. ASSEMBLING THE TOOL
SETUP & PREPARATION
1
2
3
4
6
5
7
8
9
10
11
Changing The Chuck
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
1. Pull the locking collar towards the
front of the chuck and push it onto the
driver on the front of the tool.
2. When the chuck has clicked into
place, release the locking collar.
Note:
if the chuck doesn’t click
into place, spin the collet of the chuck until
the locking collar locks into place.
3. To remove the chuck, pull the locking collar forwards again and pull the
chuck off the tool.
Attaching The Belt Clip & Accessory Holder
1. Remove the screw on either side of the tool
base.
2. Push the tabs on the accessory holder into the
slots on the tool and then replace the screw.
3. Repeat the above steps with the belt clip on
the other side of the tool.
Installing The Battery Pack
1. Slide the battery into the tool base
until it clicks into place.
2. To remove the battery, hold down
the battery release button and
slide the battery out.
LO
CK
21
19
17
a.
b.
LO
CK
21
19
17
LO
CK
21
19
17
LO
CK
21
19
17
LO
CK
21
19
17
LO
CK
21
19
17
LOCK
LOCK
LO
CK
21
19
17
