Fence Adjustment
45
0
30
0
15
0
0
0
15
0
30
0
45
0
20
40
50
60 100 120 140 160 180
90
0
OFF
Laser Line
Worklight
OFF
OFF
Laser Line
Worklight
OFF
1 Make sure that no part of the
tool contacts the upper fence
when bevel or compound mitre
cutting.
Note:
Always make a dry run with
the saw turned off and check
clearance. Tighten securely before
making a cut.
1 To unlock the saw head, press
down slightly on the handle and
then pull and rotate the head
locking pin 90 degrees.
2 To lock the head down, press
the head down and the pull and
rotate the head locking pin 90
degrees.
To switch the worklight on, press
the worklight switch up into the on
position.
To switch the laser line on, press
the laser line switch up into the on
position.
4. CONTROLS
WARNING!
DO NOT STARE DIRECTLY AT THE LASER
BEAM OR WORKLIGHT.
45
0
30 0
150
00
15
0
30
0
45
0
20
40
50
60 100 120 140 160 180
45
0
30 0
150
00
15
0
30
0
45
0
20
40
50
60 100 120 140 160 180
Starting the Mitre Saw
Head Locking Pin
Turning On the Worklight or Laser Line
2 Squeeze the on/off
trigger to start the
saw.
Note:
Allow the saw to reach full speed before beginning a cut.
1 Unlock the trigger by pressing the
lever on the trigger sideways.
Then unlock the handle motion by
pressing the handle lock button
at the front of the handle.
Trenching refers to restricting the depth of cut and permits a “trench” to be
cut in the workpiece.
Depth Adjustment (Trenching)
2 Using a hex key,
adjust the depth
adjustment screw
so that the cutting
head stops at the
desired height when
lowered.
1 Ensure the cutting head is raised,
and then loosen the depth
locking nut.
3 Once the desired setting is
achieved, tighten the depth
locking nut.
