1. Align the holes in the upper
handle and lower handle. Care
should be taken not to impinge
cord.
3. Place a washer and the handle
securing lever onto the bolt to
secure in place.
1. Lift up the grass catcher flap
while guiding the catcher into the
2 hooks.
3. To remove, raise the flap and lift
the catcher out.
2. Place the handle securing lever
bolt through the holes from the
inside.
4. Repeat this process for the
opposite side.
2. Once the grass catcher is in
place, the flap can be lowered.
Fitting the Upper Handle
Fitting and Removing the Grass Catcher
WARNING!
WHEN FITTING THE GRASS CATCHER
AFTER EMPTYING, ALWAYS ENSURE THERE IS NO
BUILD UP OF GRASS IN THE GRASS CHUTE.
IMPORTANT!
ONLY FIT AND REMOVE THE CATCHER
WHEN THE MOWER IS SWITCHED OFF AND THE
MOTOR HAS COME TO A STOP.
1. Release both quick adjustment
levers and rotate the handle into
the desired position.
2. Secure in place by tightening
both quick adjustment levers.
1. Locate cord on outside of handle.
Push the supplied cord clips over
the cord and onto the handle to
secure in place.
If the indicator flap is down while
operating then the grass catcher is full
and needs emptying.
Note
:
Care should be taken not to impinge cord when folding down the
handle.
Adjusting the Handle
Securing the Cord
Grass Catcher Indicator
Ensure the cord follows the handle smoothly from the switch to the body of
the mower.
The grass catcher is fitted with an indicator flap
at the rear of the catcher to help identify when
to empty.
1. Clip the two lower side halves
together by pushing each lug
firmly until it clicks in.
2. Align the upper part and the
lower halves and push each
individual lug into its opposite
location.
Assembling the Grass Catcher
