PXCCSSS-018
4. OPERATION
OPERATION
Prior to operation, ensure you have read and understood
the operating instructions. Ensure you wear safety gear
such as eye protection.
If multiple chains are to be sharpened, it is suggested the
sharpener be turned off at the completion of each chain for
a period equal to that of sharpening the previous chain.
Turning the tool
ON and OFF
To turn the tool on,
press the green ‘I’ button.
To turn the motor off,
press the red ‘O’ button.
Note:
When turning on the sharpener,
stand to one side of the tool. Ensure you wear
safety glasses.
Using the sharpener
Turn on the sharpener, and slowly lower the hand-piece. If you notice a slight error
in your settings, turn off the tool and remove battery prior to making any further
adjustments.
Note:
A successful grind occurs when
the contact between the wheel and tooth is
gradual and smooth.
Should the sharpener speed slow down, allow
the hand-piece to raise up a little (in effect
allowing the wheel to lift away from the
chain) and let the motor return to full speed
before continuing to sharpen.
The chain saw chain is fitted with two sets of teeth, usually every second tooth is the
opposite to the last. When there is an odd number of teeth in the chain,
the teeth can be doubled up ie. left,
left, right.
Should the chain have an odd
number of teeth, check to find
this point, and be aware of this
condition.
CAUTION:
DURING OPERATION, IT IS IMPORTANT NOT TO
OVERLOAD THE SHARPENER. THE SHARPENER SHOULD
RUN AT ALMOST FULL SPEED AT ALL TIMES. IF TOO MUCH
PRESSURE IS APPLIED, THE SHARPENER WILL START TO
SLOW DOWN (NOTICED MAINLY BY THE DRAMATIC AUDIBLE
CHANGE OF THE MOTOR.
ON
OFF
3. INSERTING & REMOVING THE BATTERY
Installing a Battery into the Sharpener
1. Align the ribs of the battery with
the recess at the back of the
sharpener.
Removing a Battery from the Sharpener
2. Slide the battery in so
that it clicks into place.
1. Press and hold the battery
release tab to release the
battery.
2. Slide the battery out.