1
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
The handles and mid handle frame need to be secured in place before
the unit can be used.
1. Place the mid-handle frame
onto the lower handle frame so
that it bends in the direction of
the user.
2. Ensure that the holes in the bars of both
handle frames are in alignment. Using two of
the handle lock knob and bolt sets, fix both
handle frames together. The knobs should be
positioned on the inside of the frame. Tighten
them securely.
3. Attach the left and right handles to the mid
handle frame with the remaining two handle
lock knobs.
4. The cross bar acts as an
additional support to the handle
frame assembly. Insert each
threaded end of the crossbar
through the matching holes in the
right and left handles. If fitting the
cross bar is too difficult, loosen
one of the upper handle lock knobs slightly.
5. Cap the threaded ends of
the cross bar with the spring
washers and nuts supplied.
Ensure all handle lock knobs
are tightened securely.
6. Use the cable clips (supplied)
to fasten the cable container to
the mid-handle frame and the
right handle.
KNOW YOUR PRODUCT
ASSEMBLY
1. Throttle lock-off
2. Throttle lever
3. On/Off switch
4. Cross bar
5. Right handle
6. Left handle
7. Mid handle frame
8. Handle lock knobs
9. Lower handle frame
10.
Recoil starter
11.
Cable container
12. Choke
13.
Spark plug
14.
Connection plate
15.
Drag stake
16. Fuel tank
17.
Air filter
18.
Primer bulb
19.
Blade guard
20.
Wheel
21.
Bar shaft sleeve
22. Blade
1. ASSEMBLING THE HANDLES
PETROL TILLER
1
2
3
5
4
11
6
12
7
13
16
8
14
17
9
10
15
20
21
22
18
19