2. DUST EXTRACTION
3. CONTROLS
1 Increase cutting depth.
1 Press and hold the lock off
switch.
2 Press the on/off switch to
start the planer.
3 Release on/off switch to
turn off.
2
1
3
2 Decrease cutting depth.
OPERATION
4 Wait until the blade stops completely before sitting the planer
down.
The planing depth can be adjusted between 0 and 3mm. The
numbers on the depth adjustment correspond to the planing depth
(mm). Always test the setting on a scrap workpiece first.
CAUTION!
THE DUST EXTRACTION CHUTE MUST
ALWAYS BE IN THE LOCKED POSITION WHIST
OPERATING AS THIS WILL ALLOW DUST TO BE
REMOVED FROM THE PLANER AND WORKPIECE.
WARNING!
THE POWER SUPPLY FOR THIS PRODUCT
SHOULD BE PROTECTED BY A RESIDUAL CURRENT
DEVICE (RATED AT 30mA OR LESS). A RESIDUAL
CURRENT DEVICE REDUCES THE RISK OF ELECTRIC
SHOCK.
2
1
3
Depth Adjustment Knob
Lock-off Trigger
1 To remove the dust extraction
chute, rotate the chute
clockwise & then slide out.
Dust Extraction Chute
2 To fit the dust extraction
chute, slide the chute into the
opening on your preferred
side.
The dust extraction chute can be installed on either side of the planer,
allowing you to determine on which side dust extraction occurs.
For optimum dust extraction, a extraction vacuum hose can be fitted to
the extraction chute by using the dust adaptor. The dust extraction chute
can be fitted either side of the housing to allow the hose to be connect
from the desired side.
Dust Adaptor
1 Push the dust adaptor
into the dust extraction
chute.
2 Connect a vacuum hose to the dust adaptor.
3 Lock in place by rotating
anti-clockwise.
