1. ASSEMBLY
SETUP & PREPARATION
WARNING!
WEAR SAFETY GLOVES - TAKE CARE THAT
YOU DO NOT INJURE YOURSELF ON SHARP CORNERS
OR EDGES.
KNOW YOUR PRODUCT
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.
A. Leg A x 2
B. Leg B x 2
C. Leg C x 2
D. Cross Strut D x 2
E. Cross Strut E x 2
CHAINSAW CUTTING STAND
F
G
H
B
A
E
B
A
D
C
H
G
I
F
I
J
F. M8x14 Bolt & Nut x 3
G. M6x28 Screw & Nut x 2
H. M6x12 Screw & Nut x 8
I. M6x12 Screw, Nut & Washer x 3
J. Safety Catch
Assembly of the Stand
The legs are constructed by assembling each half of the structure
and then joining them together.
Tools for assembly (not included): Phillips screwdriver, M10, M13 &
M14 spanners.
1. Lay three legs on the ground, parallel to each other with teeth
facing up.
2. Place cross strut E over each leg, aligning the holes with the
lower holes on each leg.
Note:
Leg C is positioned off centre to the left, this will allow
correct alignment with the second half when joining them together.
B
A
C
D
E
3. Lay cross strut D over E and all
three legs.
4. Once aligned, insert G screw
from the outside and tighten nut
on the inside (only hand tight at
this initial stage).
5. Using H screw and nut loosely
fastening the remaining legs and
cross struts together.
D
G
H
6. Once all the legs and cross struts are joined together and the
fasteners are assembled, use a spanner and screwdriver to
tension the fasteners to complete this half of the structure.